'HOW TO' fit a Hooklength in a Hooklength Box
This Article does not exist in selected language, fallback to english
Share the 'HOW TO' fit a Hooklength in a Hooklength Box article:
Partager
STEP 1
Start off by pulling your hook over the peg in your hooklength box.
STEP 2
Wrap your line around the required hooklength peg, making sure you have plenty of line to play with.
STEP 3
Once you've wrapped the line around the peg grab your line with your thumb and index finger, gripping it tightly. Then lift it over the peg.
STEP 4
This loop will form your hooklength loop. The next step is to tie a simple figure of eight knot.
STEP 5
Trim the tag off close to the loop, leaving a few mm to avoid the knot slipping.
STEP 6
Then take your hook and put it in the peg and pull your hooklength loop on to the original peg.
Finished Article
